Table of Contents
Advertisement
3. Setup
Lamp
This fixture comes with a 650 watt lamp, which must be installed prior to the first operation of the
fixture.
Warning!
When replacing the lamp, please wait 15 minutes after powering down to allow the
unit to cool down! Always disconnect from main power prior to lamp replacement.
Do not touch the envelope (glass area) of the bulb with bare hands. If this happens, clean the lamp
with alcohol and wipe it with a lint-free cloth before installation. Failure to clean the lamp after
handling with bare hands may result in premature lamp failure or fire.
Lamp Replacement
1)
Remove the two lamp cover screws located on the top of the
fixture as indicated in Figure 1.
2)
Place the lamp base plate on the fixture as indicated in Figure 2.
3)
The lamp is held in place by tension provided by springs inside of
the ceramic socket. It is important to proceed with lamp removal
and replacement very delicately.
4)
Hold lamp with a napkin as indicated in Figure 3, and pull directly
away from the base plate.
5)
Hold new lamp with a lint-free cloth and insert directly into socket.
6)
Replace top cover.
Figure 2
Stepper User Manual
Lamp Cover Screws
6
Figure 1
Figure 3
2006-12-12/09:53
Advertisement
Table of Contents
Troubleshooting
