Advertisement
1
Preparing the Machine
No Parts Required
Procedure
1.
Park the machine on a level surface.
2.
Engage the parking brake.
3.
Shut off the engine and remove the key; refer to
your Operator's Manual.
4.
If the cutting unit is installed, remove the cutting
unit from the traction unit; refer to the Operator's
Manual for the traction unit.
2
Gathering the Tools
Required for Setup
Parts needed for this procedure:
–
Torque wrench (Not included)
Note:
Ensure that the torque wrenches are capable
of torquing both clockwise and counterclockwise.
•
Torque wrench—5.2 to 6.8 N∙m (46 to 60 in-lb)
•
Torque wrench—16 to 22 N∙m (12 to 16 in-lb)
•
Torque wrench—20 to 26 N∙m (15 to 19 in-lb)
•
Torque wrench—115 to 129 N∙m (85 to 95 ft-lb)
•
Torque wrench—135 to 150 N∙m (100 to 110 ft-lb)
•
Reel driveshaft tool, Part No. TOR4112 (used only
on 5-inch reels)
•
Reel driveshaft tool, Part No. TOR4074 (used only
on 7-inch reels)
•
Long-handled pry bar (3/8 x 12 inches)
Service Tools
Oil syringe (included), Part No. 137-0872; refer to
Changing the Gearbox Lubricant (page
Drive shaft tool (optional), Part No. 137-0920; refer
to your traction unit Service Manual or contact your
authorized Toro distributor.
3
Determining the Setup
No Parts Required
Procedure
Use the following diagram to determine the position
of the groomer kit and reel motors.
1. Cutting unit 1
2. Cutting unit 2
3. Cutting unit 3
4. Cutting unit 4
Note:
roller-brush kit on the cutting unit, install the groomer
kit first.
17).
3
Figure 2
5. Cutting unit 5
6. Reel motor
7. Right groomer kit
8. Left groomer kit
If you are installing a groomer kit and a rear
g027662
Advertisement
