Husqvarna P 520DX Operator's Manual page 24

Number Cutting height, mm/in.
1 30/1.2
2 40/1.6
3 52/2
4 64/2.5
5 76/2.3
6 93/3.7
7 112/4.4
7. Tighten the cutting height adjustment knob.
8. Do the above steps on the other side of the cutting
deck.
9. Remove the locking pin on the cutting height
adjustment lever in the top left corner of the cutting
deck.
10. Push the cutting height adjustment lever down and
pull the lever horizontally.
11. Put the lever in the hole with the same number as on
the adjustment plate.
Note:
Make sure the same number is selected on
all adjustment points.
12. Attach the locking pin on the cutting height
adjustment lever.
13. Adjust the parallelism of the cutting deck. Refer to
adjust the parallelism of the cutting deck on page
33 .
To adjust the cutting height (Combi 132
X, Combi 155 X)
1. Park the product on level ground.
2. Move the lift lever for hydraulic lift forward to lower
the cutting deck to the mow position.
24
3. Move the cutting height lever forward and rearward
to adjust the cutting height.
Note:
The selected cutting height is shown with
the numbers 1–7 on the cutting deck. Refer to the
table below.
Number
1
2
3
4
5
To
6
7
4. Adjust the parallelism of the cutting deck. Refer to
adjust the parallelism of the cutting deck on page
33 .
Cutting height, mm/in.
30/1.2
40/1.6
52/2
64/2.5
76/2.3
93/3.7
112/4.4
1593 - 002 - 22.12.2020
To