Husqvarna P 520DX Operator's Manual page 17

9. Put the lift lever to the position (C) to lower the lift
arms.
C
D
WARNING:
in the mow position (D). The hydraulic
force can cause serious injury.
10. Stop the engine.
11. Remove the 2 screws and the service hatch.
12. Lift off the rubber casing from the shaft joint.
13. Pull back the coupling of the drive shaft and remove
the drive shaft from the bevel gear shaft of the
cutting deck and from the PTO shaft.
14. Remove the lock chains.
15. Remove the pins (E) and the bolts (F) from the lift
arms.
E
1593 - 002 - 22.12.2020
Do not put the lift lever
F
E
F
To remove and install the cabin
1. Remove the cabin door. Refer to
install the door on page 18 .
2. Remove the emergency door. Refer to
and install the emergency door on page 18 .
3. Remove the rubber straps and open the engine
cover.
4. Disconnect the battery.
5. Remove the service lid. Refer to
service lid on page 30 .
6. Remove the cover of the fuse box. Refer to
remove the cover of the fuse box on page 30 .
7. Disconnect the cable for cabin control. The cable
has a black plug.
8. Put the rubber grommet in the empty slot.
9. Put a cloth below the hoses for the cabin heat.
Note:
To prevent coolant leakage, make sure that
the cabin heat is off before you disconnect the
hoses.
To remove and
To remove
To remove the
To
17