Husqvarna P 520DX Operator's Manual page 23

3. Carefully push down one of the pedals. The speed
increases the more the pedal is pushed down. Use
pedal (A) to move forward, and pedal (B) to move in
reverse.
A
4. Release the pedal to brake. To brake harder, push
down the other speed pedal.
5. Pull the PTO button to engage the operation of the
blades on the cutting deck.
To set the forward pedal positions (P 525DX,
P525DX Cabin)
The forward pedal can be set to transport speed or
working speed using the lock lever.
1. Move the lock lever from position (A) to position (B)
to set the pedal to working speed.
A
B
2. Lift the pedal until the lock lever moves into position
(A) to set the pedal to transport speed.
To adjust the ground pressure of the
hydraulic lift arms
The hydraulic lift arms has a lift spring that helps to
increase or decrease the ground pressure from the pivot
wheel on the cutting deck.
1. Remove the cutting deck. Refer to
cutting deck on page 16 .
2. Apply the parking brake.
1593 - 002 - 22.12.2020
3. Move the lever for the hydraulic lift arms rearward to
4. Turn the ignition key to the STOP position.
5. To increase or decrease the ground pressure,
B
To adjust the cutting height Combi 132,
Combi 155
1. Park the product on level ground.
2. Apply the parking brake.
3. Move the lever for the hydraulic lift arms rearward to
4. Turn the ignition key to the STOP position.
5. Remove the cutting height adjustment knob on the
6. Put the cutting height adjustment knob in 1 of the
To remove the
fully lift the hydraulic lift arms.
remove the pin and the bolt and move the lift spring
to one of the positions.
A
B
C
D
a) Use position (A) for the lowest ground pressure.
Position (A) is used for example when a cutting
deck is attached to the product.
b) Use position (B) or (C) for increased ground
pressure.
c) Use position (D) to disengage the lift spring.
Position (D) is used for example when a snow
blade is attached to the product.
fully lift the cutting deck.
side of the cutting deck.
holes on the adjustment plate.
Note:
The cutting height is shown with the
numbers 1–7. Refer to the table below.
23