Saturn ST-AH2109 Manual page 5

Air humidifier
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1
SHORT CORD INSTRUCTIONS
• A short power-supply cord should
be used to reduce the risk resulting
from becoming entangled in or
tripping over a longer cord.
• Extension cords may be used if
care is exercised in their use and if
they are of proper voltage and plug
compatibility.
- If extension cord is used:
1. The marked electrical rating of the
cord set or extension cord should be
at least as great as the electrical
rating of the appliance; and
2. The cord should be arranged so
that it will not drape over the
countertop or tabletop where it can
be pulled on by children or tripped
over unintentionally.
Service life – 3 years.
Before putting into operation shelf
life is unlimited.
BEFORE THE USE
HUMIDIFIER PLACEMENT
Place the humidifier on an elevated,
non-metallic, lint-free, water-
resistant, level surface at least 5
inches away from walls, heat
sources, and ledges.
DO NOT place on carpet, towel or
fabrics. The fan vent is located on
the bottom of the water basin. The
fan vent MUST NOT be obstructed.
DO NOT place the humidifier on a
wooden surface or near furniture
that can be damaged by moisture.
CHECK FAN VENT
The Fan Vent is located on the
bottom of the humidifier. The
purpose of the Fan Vent is to blow
the cool mist through the Mist Outlet
Slots. It is important that this part
be kept clean and free of any
obstructions. We recommend
checking the fan vent before using
this item (i.e. free of lint, paper,
etc.).
Do not place the humidifier on top of
a towel or a carpeted surface. The
Fan Vent on the bottom may become
blocked and overheat the humidifier.
CAUTION: DO NOT operate the
humidifier without water in the
Water Tank.
DO NOT plug or unplug the Power
Cord with wet hands as electric
shock could occur.
INSTRUCTIONS FOR USE
NOTE: This is a Cool Mist humidifier.
The mist should be cool mist. There
is no steaming or boiling of water.
1. Make sure the unit is plugged and
in off position.
2. Remove the adjustable misting
outlet.
3. Lift the Water Tank and turn
upside down.
4. Unscrew cap from Water Tank
Cover by turning cap
counterclockwise.
5. Fill the Water Tank with desired
amount of clean water to the max fill
line. Never fill all the way up to the
water tank rim.
Note: To avoid lime scale build-up
due to hard water, it is
4

Advertisement

Table of Contents
loading

Table of Contents