Jensen MP1314 Owner's Manual page 6

7. Reconnect the wire harness and the antenna being careful not to pinch any
wires or cables.
8. Slide the unit into the sleeve until it locks into place.
9. To further secure the unit, use the supplied metal strap to secure the back of
the unit in place. Use the supplied hardware (Hex Nut, M5mm) and Spring
Washer) to attach one end of the strap to the mounting bolt on the back of
the unit. If necessary, bend the metal strap to fit your vehicle's mounting area.
Then use the supplied hardware (Tapping Screw and Plain Washer) to attach
the other end of metal strap to a solid metal part of the vehicle under the
dashboard. This strap also helps ensure proper electrical grounding of the
unit.
Note: Install the short threading terminal of the mounting bolt to the back of the
unit and the other long threading terminal to the dashboard.
(1) Metal Strap; (2) Mounting Bolt; (3) Hex Nut; (4) Spring Washer;
10. Reconnect the cable to the vehicle battery's negative (-) terminal. Then replace
the outer trim ring and install the unit's front panel (refer to "Installing the
front panel").
6
(5) Tapping Screw; (6) Plain Washer
MP1314