Troubleshooting - Jensen MP1314 Owner's Manual

TROUBLESHOOTING

Before going through the checklist, the check wiring connections. If any of the
problems persist after checking the list, contact your nearest service dealer.
Symptom Cause
No power. • The car ignition switch is
• The fuse is blown.
Disc cannot • A disc is loaded inside the
be loaded or
ejected.
• The disc is inserted in the
• Compact disc is extremely
• The temperature inside the
• Condensation.
No sound. • The volume is at minimum.
• The wiring is not properly
CD audio • The installation angle is
skips.
• The disc is extremely dirty.
• The disc is defective.
The • The built-in microcomputer
operation
keys do not
work.
The radio • The antenna cable is not
does not
work.
The radio • The signals are too weak.
station
automatic
selection
does not
work.
22
not on.
player.
wrong direction.
dirty or defective.
car is too high.
connected.
greater than 30 degrees.
is not operating properly
due to noise.
connected.
Solution
• If the power supply is
connected to the car
accessory circuits, but the
engine is not running, switch
the ignition key to "ACC".
• Replace the fuse.
• Remove the disc in the player,
then insert a new one.
• Insert the compact disc with
the label facing upward.
• Clean the disc or try to play a
new one.
• Let vehicle temperature cool.
• Turn the player off for an hour,
then try again.
• Adjust the volume to a desired
level.
• Check the wiring connection.
• Adjust the installation angle
to less than 30 degrees.
• Clean the compact disc.
• Play a new compact disc.
• Press the RESET button.
• The front panel is not properly
installed.
• Insert the antenna cable
firmly.
• Select a station manually.
MP1314