Table of Contents
Advertisement
Available languages
Available languages
aSSEmBly INStructIoNS
toolS rEQuIrEd For aSSEmBly
(2)
9/16" Wrenches
(2)
1/2" Wrenches
(2)
7/16" Wrenches
(1)
Pliers
(1)
Grease Gun
1. Attach the wheel support (3) to the middle of the cart
bed (2) using eight 5/16 x 1-1/4" hex bolts (12) and
5/16" nylock nuts (17). tighten.
5/16 X 1-1/4"
HEX Bolt
WHEEl
Support
FIGurE 1
2. Assemble the latch stand bracket (6) to the cart bed
using four 1/4 x 1" hex bolts (15) and 1/4" nylock nuts
(19). tighten.
latcH StaNd
BracKEt
FIGurE 2
5/16" NylocK Nut
1/4 X 1"
HEX Bolt
1/4" NylocK
Nut
4
3. Turn cart over and place tongue (8) on latch stand
bracket (6) and wheel support (3).
4. Slide axle through wheel support and tongue.
aXlE
FIGurE 3
5. Assemble the step bracket (10) to the latch lock
bracket (9) using two 5/16 x 3/4" hex bolts (14) and
5/16" nylock nuts (17). tighten.
5/16 X 3/4"
HEX Bolt
latcH locK
BracKEt
FIGurE 4
6. Slide the step bracket (10) and latch lock bracket (9) into
the slot in the tongue (8).
7. Secure the step bracket (10) and latch lock bracket (9) to
the tongue (8) using a 5/16 x 4" hex bolt (11), a 5/16" sims
nut (18) on each side of the brackets and a 5/16" nylock nut
(17). Do not over tighten nylock nut, the bolt must pivot.
8. Attach the short end of extension spring (25) to the hole at
the bottom of the latch lock bracket (9).
9. Use the spring puller (27) tool to pull the long end of the
extension spring (25) down and attach it to the tongue (8).
5/16" SImS Nut
5/16" NylocK Nut
SprING pullEr tool
FIGurE 5
toNGuE
5/16" NylocK Nut
StEp BracKEt
5/16" X 4" HEX Bolt
EXtENSIoN SprING
Advertisement
Table of Contents
