Overcasting Using The Side Cutter - Brother ULT-2002D Operation Manual

Overcasting Using the Side Cutter

By using the side cutter, you can do overcasting while cutting the fabrics.
1
1
2
1. Push the "Needle Position" button to raise the needle,
then turn off the power.
2. Raise the presser foot lever.
2
3. Press the black button on the presser foot holder, and
remove the presser foot.
4. Use the included screwdriver to loosen the screw of
the presser foot holder, and remove the presser foot
holder.
2
5. Set the fork of the operating lever around the needle
clamp screw.
5
1 Needle clamp screw
2 Operating lever
1
* Make sure that the fork of the operating lever is set
onto the screw firmly.
Sewing Utility Stitches
1 —
2 —
3 —
4 —
5 —
6 —
7 —
8 —
9 —
3-25