Handling Guidelines; Maintenance; Operating Conditions - Suunto TANK POD Safety And Regulatory Information Manual

Hide thumbs Also See for SUUNTO TANK POD:
Table of Contents

Advertisement

Available languages
  • EN

Available languages

  • ENGLISH, page 1

HANDLING GUIDELINES

Handle Suunto Tank POD with care. The sensitive internal electronic components
may be damaged if the device is dropped or otherwise mishandled.
When traveling with this device ensure that it is packed securely in check-in or
carry-on luggage. It should be placed in a bag or other container where it cannot
move around, be bumped or easily hit.
Do not try to open or repair Suunto Tank POD by yourself. If you are experiencing
problems with the device, please contact your nearest authorized Suunto Service
Center.
Store the Suunto Tank POD in a dry place at room temperature.
WARNING: ENSURE THE WATER RESISTANCE OF THE DEVICE! Moisture inside
the device may seriously damage the unit. Only an authorized Suunto Service
Center should do service activities.
NOTE: Thoroughly rinse the device with fresh water, mild soap and carefully
clean the housing with moist soft cloth or chamois after diving, especially after
salt-water dives.
WARNING: Use only original Suunto accessories - damage caused by non-
original accessories is not covered by warranty.
TIP: Remember to register your Suunto Tank POD at
personalized support.
OPERATING TEMPERATURE
Low temperature or an internal oxidation of the battery may activate the battery
warning even though the battery has enough capacity. In this case, the warning
usually disappears when the dive mode is activated again.

MAINTENANCE

Maintenance interval and battery replacement: after 200 dives or two years,
whichever comes first. Please bring your device to an official Suunto Service.

OPERATING CONDITIONS

• Maximum depth of operation: 150 m (492 ft) (complying with EN 13319)
• Operating temperature: 0 °C to 40 °C (32 °F to 104 °F)
• Storage temperature: -20 °C to +50 °C (-4 °F to +122 °F)
NOTE: Store in a dry place at room temperature.
PRESSURE MEASUREMENTS
• Rated working pressure: 300 bar / 4000 psi
• Max. allowed pressure: 400 bar / 5800 psi
BATTERY
• Type: 1/2 AA Primary lithium-thionyl chloride (Li-SOCl2)
suunto.com/register
to get
5

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dp142

Table of Contents