If The Bobbin Thread Breaks Or Runs Out - Brother PR-620 Operation Manual

OTHER BASIC PROCEDURES
If the bobbin thread breaks or
runs out
1 Touch , and then press the thread
trimming button.
The upper thread is trimmed.
• If the bobbin thread breaks or runs out, also
trim the upper thread.
2 Remove the stitches sewn only with the upper
thread.
Pull the trim end of the upper thread.
• If the stitches cannot be cleanly removed,
trim the thread with scissors.
80
—————————————————————————————————————————————
■ If the bobbin thread ran out, replace the bobbin
at this point in the procedure.
3 Replace the bobbin with a bobbin wound with
bobbin thread. (Refer to page 18.)
• If the hook cover can be opened, replace the
bobbin without removing the embroidery
frame from the machine.
• If the machine bed is hidden, for example,
with a bag-shaped piece of fabric, or if the
hook cover cannot be opened, temporarily
remove the embroidery frame. (Refer to
page 46.) After replacing the bobbin, re-
attach the embroidery frame. (Refer to
page 30.)
Note
If the embroidery frame is removed before
embroidering of the pattern is finished, be
careful of the following, otherwise the pattern
may become misaligned.
● Do not apply extreme pressure to the
framed fabric and cause it to become loose.
● When removing and re-attaching the
embroidery frame, do not allow the frame to
hit the carriage or the presser foot.
If the carriage is hit and moves, turn the
machine off, then on again. The correct
frame position at the time that the machine
was stopped is stored in the machine's
memory, and the embroidery frame is
returned to the correct position.
● When the embroidery frame is re-attached,
make sure that the pins on the left and right
arms of the embroidery frame holder
securely fit into the holes in the handles on
the embroidery frame.
4 Go back through the stitching in the same way
as that described in step
thread breaks" on page 79, and then continue
embroidering.
2
of "If the upper