Setting Up The Machine - Brother PR-620 Operation Manual

GETTING READY ———————————————————————————————————————————————————
.

Setting up the machine

When setting up the machine, adjust the legs so that
the machine is steady.
1 Make sure that all packing tape affixed to the
machine is peeled off and that all packing
material is removed.
2 Set up the machine while making sure that
there is sufficient space around it.
More than 512 mm
250 mm (20-5/32 inches)
(9-7/8 inches)
3 Adjust the legs so that the machine is steady.
Use the included wrench to loosen the lock
nut on the leg that you wish to adjust.
1
2
1 Lock nut
2 Adjustable foot nut
The foot can be turned.
8
More than
50 mm
(2 inches)
589 mm
(23-3/16
inches)
More than
350 mm
(13-3/4 inches)
More than
250 mm
(9-7/8 inches)
4 Use the included wrench to turn the
adjustable foot nut on the foot.
Turning the nut in direction 1 lengthens the
leg; turning the nut in direction 2 shortens the
leg.
1
1 Adjustable foot nut
• Adjust all four legs so that they securely
contact the desk or table.
5
After adjusting the legs to the desired length,
use the included wrench to tighten the nuts.
1
1 Lock nut
6 Press down on each corner of the embroidery
machine to check that it is stable.
If it is still unstable, perform steps
5
again to adjust the legs.
2
1
3
through