Attaching The Embroidery Frame To The Machine; Attaching The Embroidery Frame - Brother PR-620 Operation Manual

EMBROIDERING TUTORIAL ——————————————————————————————————————————————

8. Attaching the Embroidery Frame to the Machine

After hooping the fabric in the embroidery frame, attach the frame to the embroidery machine.
CAUTION
●
If the embroidery frame is not correctly attached it may hit the presser foot and damage the
machine, or cause injury to the user.
●
When attaching the embroidery frame, make sure that the start/stop button is lit in red. If the
start/stop button is flashing in green, the embroidery machine may start sewing. If the
embroidery machine accidentally starts operating, injuries may result.
●
When attaching the embroidery frame, make sure that the embroidery frame does not hit any
other part of the embroidery machine.
Note
● Before attaching the embroidery frame, check that there is enough thread in the bobbin.

Attaching the embroidery frame

Adjust the width of the embroidery frame holder to the size of the embroidery frame, and then attach the
embroidery frame to the machine. As an example, the procedure for attaching the small embroidery frame is
described below.
Embroidery frame
Positioning slots
30
Holes
Left arm of embroidery frame holder
Move the arm of the embroidery frame holder to the left or
right to adjust it to the size of the embroidery frame.
Clip on embroidery frame holder.
Insert the embroidery frame into the clips
Positioning Pin
on the embroidery frame holder.