Installation - Whirlpool AKG668 Instructions For Use And Installation

AKG668 Installation & Instructions for Use
SITING THE OVEN
The AKG668 is designed to be
installed either into a housing unit,
or between base units.
ELECTRICAL CONNECTION
The appliance must be installed
by a competent electrician and
connected to
regulations, to a cooker control
unit of 30 amp minimum capacity,
incorporating a double pole switch
having contact separation of at
least 3mm at all poles. It is wired
for single phase operation and
must be earthed. Access to the
mains terminal connections is
gained by removing the panel at
the left hand rear of the appliance.
Connect the cable to the terminal
block, then position the cover
plate in the rear panel, and tighten
the cable clamp screw before
securing the cover.
IMPORTANT
The wires of the mains lead for
this appliance must be connected
in accordance with the following
code:

INSTALLATION

l.E.E. wiring
As the colours of the wires in the
mains lead you may use to
connect this appliance may not
correspond with the markings on
the terminals, please proceed as
follows.
Brown (or Red) = Live
Blue (or Black) = Neutral
Green/Yellow (or Green) = Earth
If you are in any doubt as to the
correct connections, consult a
qualified electrician.
Before using the oven remove
any protective polythene film and
wash the oven shelves and
furniture in hot soapy water to
remove their protective covering,
of oil.
IN THE EVENT OF A POWER
CUT
1. SWITCH OFF the electricity
supply to the appliance.
2. When the power returns you
MUST reset the-programmer to
show the time of day, see page 7,
until this is done the oven and the
grill CANNOT be used.
3