Whirlpool AKG668 Instructions For Use And Installation page 25

AKG668 Installation & Instructions for Use
METHOD 1Without housing unit
(Between 2 base units)
BEFORE installing the appliance,
check the internal dimensions as
shown in the illustration. The
space for the appliance must be
clear of obstructions, and there
must be enough space at the
back of the oven to obtain the
550mm minimum depth.
The FIXING KIT is packed onto
the oven under the polystyrene
packaging. You will find 2 side
trims 692mm long and 4 runners
420mm. Long. The fixing screws
are in a polythene bag in the oven
pack.
1. REMOVE the 6 screws (3 each
side) from the lower sides of the
oven. Take 4 of the No. 8 x 1 2mm
(Silver) self tapping screws from
the polythene bag, and use them
to fit one runner to each side, of
the appliance.
2. Make sure they are the RIGHT
WAY up as shown.
3. Take one of the side trims, hold
it against the side of the base unit,
and mark off 692mm from the top
edge of the base unit, to the top
edge for the runner.
INSTALLATION METHOD 1
NOTE:
This ensures a 5mm to 8mm
clearance from the underside of
the worktop to the top of the
appliance.
4. Measure 50mm from the front
edge of the base units, to mark
the front edge, of the runners.
5. Take 6 of the No.8 x 12mm.
(Black) chipboard screws and
screw the runners into position the
RIGHT WAY up as shown.
6. Fit the side trims to be FLUSH
to the top and front edges of the
base units, using the remaining 6
No. 8 x 12mm. (Black) chipboard
screws,
CONNECTION
ELECTRICITY SUPPLY
See page 3.
Insert the appliance between the
base units. CARE must be taken
to ensure the appliance runners
are sufficiently engaged over the
top of the runners on the base
units.
23
TO THE