Stihl MS 201 TC-M Instruction Manual page 27

25 Maintaining and Sharpening the Saw Chain
WARNING
Depth gauges that are too low increase the kick‐
back tendency of the chain saw.
► Lay the file gauge on the saw chain – the high‐
est point of the depth gauge must be flush with
the file gauge
► After sharpening, clean the saw chain thor‐
oughly, removing any filings or grinding dust –
lubricate the saw chain thoroughly
► In the event of extended periods of disuse,
store saw chains in cleaned and oiled condi‐
tion
Sharpening tools (special accessories)
Chain pitch Round file
^
Inches (mm) mm (Inches
)
1/4P (6.35) 3.2 (1/8)
1/4 (6.35) 4.0 (5/32) 5605 772 40065605 750 43271110 893 40000814 252 33565605 007
3/8 P (9.32) 4.0 (5/32) 5605 772
0.325 (8.25) 4.8 (3/16) 5605 772
3/8 (9.32) 5.2 (13/64) 5605 772
0.404 (10.26) 5.5 (7/32) 5605 772
1)consisting of file holder with round file, taper square file and file gauge
0458-599-0121-C
Round file File holder
Part number Part number
5605 771 5605 750
3206 4300
5605 750
4006 4327
5605 750
4806 4328
5605 750
5206 4329
5605 750
5506 4330
File gauge Taper square
file
Part number Part number
0000 893 0814 252
4005 3356
1110 893 0814 252
4000 3356
1110 893 0814 252
4000 3356
1110 893 0814 252
4000 3356
1106 893 0814 252
4000 3356
English
Sharpening
1)
set
Part number
5605 007
1000
1027
5605 007
1027
5605 007
1028
5605 007
1029
5605 007
1030
27