Capital CGSR484BBL Use And Care & Installation Manual page 38

STEP 4: INSTALLING ANTI-TIP DEVICE
For all Ranges, an anti-tip device MUST be installed
as per these instructions.
WARNING!

ALL RANGES CAN TIP

INJURY TO PERSONS COULD RESULT

INSTALL ANTI-TIP DEVICES PACKED WITH
RANGE

SEE INSTALLATION INSTRUCTION
WARNING: RANGE TIPPING HAZARD!

All ranges can tip and injury can result. To
prevent accidental tipping of the range, attach
it to the floor, wall or cabinet by installing the
Anti-Tip Device supplied.

A risk of tip-over may exist if the appliance is
not installed in accordance with these instruc-
tions.

If the range is pulled away from the wall for
cleaning, service or any other reason, ensure
that the Anti-Tip Device is properly re-engaged
when the range is pushed back against the
wall. In the event of abnormal usage (such as
a person standing, sitting, or leaning on an
open door); failure to take this precaution can
result in tipping of the range. Personal injury
might result from spilled hot liquids or from the
range itself.
WARNING: ELECTRICAL SHOCK HAZARD!

Use extreme caution when drilling holes into
the wall or floor. There may be concealed
electrical wires located behind the wall or under
the floor.

Identify the electrical circuits that could be affected
by the installation of the Anti-Tip Device, then
turn off power to these circuits.
INSTALLATION INSTTRUCTIONS

Failure to follow these instructions may result
in electrical shock or other personal injury.
CAUTION: PROPERTY DAMAGE!

Contact a qualified installer or contractor to
determine the proper method for drilling holes
through the wall or floor material (such as ceramic
tile, hardwood, marble, etc.)

DO NOT slide range across unprotected floor.

Failure to follow these instructions may result
in damage to wall or floor coverings.
TOOLS NEEDED FOR INSTALLATION
OF ANTI-TIP DEVICE!
1. Screwdriver, Phillips
2. Drill, electric or hand
3. Measuring tape or ruler
4. 1/8" drill bit (wood or metal wall or floor)
5. 3/16" anchors, drywall, or concrete, 2 each (not
required if mounting bracket is being attached to
solid wood or metal.
6. Hammer
IMPORTANT INSTALLATION INFOR-

The Anti-Tip Bracket may be attached to a solid
wood cabinet having a minimum wall thickness of 3/4".
CULINARIAN SERIES

The thickness of the wall or floor may require use of
longer screws, available at your local hardware store.

In all cases at least one (1) of the bracket mounting
screws must be fastened to solid wood or metal
on each side.

Use appropriate anchors when fastening the mount-
ing bracket to any material other than hardwood or
metal.
MOUNTING ANTI-TIP BRACKET:
The alternative floor mounted bracket shall
be installed as follows:

Place bracket on floor in position shown in Figure below.

Secure to floor or wall stud.

Later, when unit is installed, the adjustable leg will slide
under the bracket
STEP 5: GAS CONNECTION AND HOOK-UP
Verify the type of gas being used at the installation
site matches the gas type of the range. As shipped
from the factory, units are configured for use with
Natural Gas or Propane (LP). Make certain the range
matches the type of gas available at the location.
For installation of the appliance at high altitude,
please consult your local gas company for their
recommendation of the correct orifice sizes and any
other necessary adjustments that will provide proper
gas combustion at specified altitudes.
NOTE: Capital DOES NOT supply ranges to match
varying altitudes. Orifices to adjust for combustion for
differing altitudes may be purchased through Capi-
tal Cooking Equipment by calling our Parts De-
partment at 1-866-4024600, or email us at cus-
tomerservice@capital-cooking.com.
38