Advertisement
TM 11-6625-1589-15-1
RANGE Switch :
Selects frequency range .
In OFF position the
oscillator is inoperative .
Frequency Dial :
Selects frequency within desired range .
Dial
calibration multiplied by RANGE switch position indicates output
frequency .
Frequency Vernier :
Provides fine tuning of frequency dial .
AMPLITUDE Control :
Selects desired output level from 0 to 5
volts rms .
( 2.5 volts rms into 600 ohms) .
Output Terminals :
Provides a 600 ohm output at a frequency and
amplitude determined by control settings.
6
2.
Provides an output sync signal of 1.7 volts rms .
Ground Strap :
Connects the floating circuit chassis to ground .
Voltage Selector Switch :
Selects line voltage of 115 volts or 230
volts ac .
AC Power Receptacle:
Mates with AC power cord supplied with
this instrument for line voltage connection .
NORM / LOW DIST . Switch :
Selects normal or low distortion on
the X5 and X10 ranges ( see Paragraph 3-14 ) .
CHARGE RATE Switch :
( Option 02 only)
Selects SLOW or FAST
rate of recharging the nickel - cadmium cells .
P/o Figure 3-1 .
Description of Controls , Indicators and Connectors
Advertisement
