Printer Is Not Using Font You Selected From The Operator Panel; Printout Curls; Computer Indicates Device Time-Out - Canon BJC-70 User Manual

Problem
Printer is not using font
you selected from the
operator panel

Printout curls

Computer indicates
device time-out
Chapter 8
Cause
Your software may be
overriding the settings.
Your page may include a
dense amount of ink.
A device time-out occurs
when your computer sends
data to the printer but the
printer does not respond.
The printer may be off,
off-line, or not connected to
the computer.
Solution
Change the initialization or
setup string that your
software sends. You may
need to do this using a menu
or screen provided by your
application software. See
your application user's
manual for information
about how your software
works with your printer.
To enable the font typeface
lock function, set
FUNCTION 8 to ON. When
on, the printer will always
print with the font you select
from the operator panel.
Remove the printout
immediately and let it dry,
then roll it in the direction
opposite to the curl.
Make sure the printer is
turned on and on-line.
Check that the printer's
interface cable is securely
attached to both the printer
and the computer.
Make sure paper is properly
loaded in the sheet feeder.
Try the print operation
again.
If you want your computer
to continuously retry
sending data to the printer's
parallel port, add the
following statement to your
AUTOEXEC.BAT file:
MODE LPT1,,P
Troubleshooting
127