Napoleon Vector Series Owner's Manual page 25

The GGA-1 mount bracket holes should be lined up with the screw holes of the GGA-1 slider brackets
8.
to ensure a clear line of sight (Fig. 8). It is typically necessary to raise the GGA-1 on both sides using
the vertical adjustment screws. Raising the GGA-1 approximately 1/8" typically provides the optimum
preliminary fit (Fig. 9). Repeat on other end of GGA-1.
DO'S
Hold GGA-1 and GGA-1 slider bracket together firmly whilst
tightening fasteners. Repeat on other end of GGA-1.
DON'TS
Gap
Fig. 10
No gap
Clear line
of sight
Fig. 7
Ensure there is no gap between back of GGA-1
and GGA-1 slider bracket at top and/or bottom.
Repeat on other end of GGA-1.
Typically 1/8"
Vertical Adjustment
Screw
maintenance
Fig. 8
Fig. 10
Horizontal
adjustment
screws
installed
unevenly
and/or
prematurely.
Fig. 11
W415-2036 / D / 08.05.21
EN
25