Bontrager Transmitr Quick Start Manual

About this Manual
This is the quick start manual for your
TransmitR lighting system. Check for
updates at bontrager.com.
TransmiTr
Quick Start Manual
This manual gives basic instructions on
the installation and use of the Bontrager
TransmitR lighting system, which is
ANT+ compatible. For the complete
manual, check our web site
www.bontrager.com/support/
The full manual includes this
additional information:
• Pairing
• Listing of all modes, run times
• Troubleshooting
• Battery types (and installation
in Remote)
• Turn signal and high beam headlight
function
• Recycling and disposal
• Compliance info
• Warranty
IMPORTANT:
Always consult your local traffic and
lighting laws prior to using a new lighting
product on your bicycle. Not all lighting
configurations are legal in all locations.
"To see" light
The Ion 700 RT is a "To See" light, a
headlight for primary vision when riding in
low light. It can also function as a "To Be
Seen" light when in flash mode, although
the amber side lenses do not direct a
substantial amount of light. Note that for
best results, a rider should employ BOTH
a To See light and a To Be Seen light.
sETUP
Pairing the TransmitR Remote to
TransmitR Lights
nOTE: If you purchased the TransmitR
Wireless Light Set, [Part Number 503063]
with the Ion 700RT, Flare RT and
TransmitR Remote in one package, skip
ahead to section 'Using the TransmitR
Remote'
BT15_MANUAL_TransmitR_QuickStart_v9.indd 1
1. For each light to be paired, quick-
press the power button on the light, then
press and hold the power button to turn
off.
2. Place all TransmitR lights to be paired
within 15cm/6 inches of the remote.
3. Press and hold the center button on
the remote for 8 seconds until the corner
buttons begin flashing.
The remote will find a TransmitR light and
the light will begin flashing. At the same
time, the center button on the remote
will turn from red to green, signifying a
connection.
4. Press the corner button on the remote
that you would like to have paired to the
light. The light will stop flashing when
it has been paired to the remote. The
center button will change back to red
and search for additional lights to pair.
5. If the remote locates another light,
repeat step 4.
6. When all TransmitR lights (up to seven)
have been paired, press the center
button of the remote to exit pairing. It will
turn from red to OFF.
Your TransmitR system is now paired and
ready for use.
UsinG THE
TransmiTr rEmOTE
Controlling Lights with the
TransmitR Remote
To turn on all lights
ON: Quick-press the center button.
OFF: Press and hold the center button.
To turn on an individual light
ON: Quick-press the corner button that
controls the light.
Corner Buttons OFF: Press and hold the same button.
-Control individual lights
To change modes of an
-Shows light mode when
pressed
individual light
Each quick-press of a button that
Center Button
controls a light will cycle through the
-System On/Off (all lights)
modes.
-Shows battery status of
light when paired button
seeing Battery Power status of the
is pressed
light on the remote
When a corner button is pressed, the
center button will show the battery status
of the light
Button light color
Green
red
Blinking red
Welcome.
Power remaining
More than 25%
Between 5% and 25%
Less than 5%
1/23/15 11:45 AM