Bontrager TransmitR Quick Start Manual

About this Manual
This is the quick start manual for your
TransmitR lighting system. Check for
updates at bontrager.com.
TransmiTr
Quick Start Manual
This manual gives basic instructions on
the installation and use of the Bontrager
TransmitR lighting system, which is
ANT+ compatible. For the complete
manual, check our website at:
www.bontrager.com/support/
The full manual includes this
additional information:
• Pairing
• Listing of all modes, run times
• Troubleshooting
• Battery types (and installation
in Remote)
• Turn signal and high beam headlight
function
• Recycling and disposal
• Compliance info
• Warranty
IMPORTANT:
Always consult your local traffic and
lighting laws prior to using a new lighting
product on your bicycle. Not all lighting
configurations are legal in all locations.
"To see" light
The Ion 700 RT is a "To See" light, a
headlight for primary vision when riding in
low light. It can also function as a "To Be
Seen" light when in flash mode, although
the amber side lenses do not direct a
substantial amount of light. Note that for
the best results, a rider should employ
BOTH a To See light and a To Be Seen
light.
sET UP
Pairing the TransmitR Remote with
TransmitR Lights
nOTE: If you purchased the TransmitR
Wireless Light Set, [Part Number
503063] with the Ion 700RT, Flare RT
and TransmitR Remote in one package,
skip ahead to the section on 'Using the
Corner Buttons
-Control individual lights
-Shows the light mode
when pressed
Centre Button
-System On/Off (all lights)
-Shows the battery status
of the light when the
paired button is pressed
Welcome.
TransmitR Remote'
1. For each light to be paired, quick-
press the power button on the light, then
press and hold the power button to turn
off.
2. Place all TransmitR lights to be paired
within 15 cm/6 inches of the remote.
3. Press and hold the centre button on
the remote for 8 seconds until the corner
buttons begin flashing.
The remote will find a TransmitR light and
the light will begin flashing. At the same
time, the centre button on the remote
will turn from red to green, signifying a
connection.
4. Press the corner button on the remote
that you would like to have paired to the
light. The light will stop flashing when
it has been paired to the remote. The
centre button will change back to red
and search for additional lights to pair.
5. If the remote locates another light,
repeat step 4.
6. When all TransmitR lights (up to seven)
have been paired, press the centre
button of the remote to exit pairing. It will
turn from red to OFF.
Your TransmitR system is now paired and
ready for use.
UsinG THE
TransmiTr rEmOTE
Controlling Lights with the
TransmitR Remote
To turn on all lights
ON: Quick-press the centre button.
OFF: Press and hold the centre button.
To turn on an individual light
ON: Quick-press the corner button that
controls the light.
OFF: Press and hold the same button.
To change mode on an
individual light
Each quick-press of a button that
controls a light will cycle through the
modes.
seeing the Battery Power status of
the light on the remote
When a corner button is pressed, the
centre button will show the battery status
of the light
Button light colour
Green
red
Blinking red
Power remaining
More than 25%
Between 5% and 25%
Less than 5%