Receiving When An Answering Machine Is Connected: Ansmode - Canon imageCLASS MF5750 Facsimile Manual

4
Press [ (-)] or [ (+)] to select <FAX/TEL OPT. SET> ➞ press [Set]
twice.
5
Press [ (-)] or [ (+)] to select the time 0 to 30 seconds that the
machine takes to check whether a call is fax or voice call ➞ press
[Set] twice.
6
Press [ (-)] or [ (+)] to select the length of time 15 to 300
seconds that the machine rings when the call is a voice call ➞
press [Set] twice.
7
Press [ (-)] or [ (+)] to select whether the machine switches to
receive mode or disconnects the call if no one answers a voice
call after the specified time in step 6 ➞ press [Set].
5
You can select from the following:
- <RECEIVE> to switch to receive mode
- <DISCONNECT> to disconnect the call
8
Press [Stop/Reset] to return to the standby display.
Receiving When an Answering Machine Is Connected:
AnsMode
If you want to select <AnsMode>, check the following:
■ Select This Mode If:
•
you only have one telephone line for both fax and telephone use.
•
you want to receive faxes automatically and receive voice messages on your answering
machine.
■ You Will Need to:
•
set <AnsMode>. (See "Setting the Receive Mode," on p. 5-1.)
•
connect an answering machine to the machine. (See "Connect the telephone cable and
necessary external device," in the Set-Up Instructions (for MF5750 users) or Set-Up
Instructions for the Machine (for MF 5770 users).)
NOTE
Follow the guidelines below to adjust the answering machine:
5-4
Setting the Receive Mode