Install Cartridge; Load Paper - Canon imageCLASS D660 Setup Instructions

2

INSTALL CARTRIDGE

3

LOAD PAPER

A
Remove the
new cartridge
from its bag.
C
Place the cartridge
on a flat and stable
surface, grip the
sealing tape tab
and snap in the
direction shown.
Make sure that the
tab is detached from
the cartridge.
E
Remove the
sealing tape
completely.
A
Grip the cassette
handle, and pull
out towards you
until the cassette
comes to a stop.
C
B
Hook the tab on
the output tray
onto the opening
on the machine.
B
Rock the cartridge
5 or 6 times to
distribute the
toner evenly.
D
Grasp the cartridge
with one hand, firmly
and slowly pull the
sealing tape tab with
the other hand.
F
Position the arrow mark
on the cartridge towards
the inside of the machine,
and gently slide the
cartridge in the machine
as far as it will go.
Close the cartridge cover
and slide the platen unit
to the original position.
Load the paper stack beneath
the cassette's length guide (1)
and width guide's claws (2).
Make sure that the paper stack does
not exceed the length and width
guide's claws in the cassette. Failure
to do so will cause a paper jam.
Gently insert the cassette as
far as it will go.