Kenwood TH-K2AT Service Manual page 5

4. Packing (G53-1572-02) TX/ BUSY lamp installation
procedure
(1)To assure w aterproofing, install the packing in the chassis
groove as show n in Fig. 5. (
(2)Install the packing TX/BUSY lamp section on the chassis.
x
( )
z
OK
Packing
Chassis
NG
Packing
Chassis
Fig. 5
5. Packing (G53-1572-02) bottom installation procedure
(1)Before installing the numeric key PCB (TX-RX unit B/3) on
the chassis, push three parts of the packing to contact tightly
w ith the chassis as show n in Fig. 6. If the packing is not in
contact w ith the chassis, there may be a gap betw een the
transceiver bottom case assembly and the battery, and
w ater may enter through the gap.
OK
Push three parts of the packing to
contact tightly w ith the chassis.
Fig. 6
DISASSEM BLY FOR REPAIR
z
)
x
NG
Clearance NG
TH-K2AT/K2E/K2ET
6. Cautions for installing the chassis on the case assembly
(1)Verify that the packing (G53-1572-02) TX/BUSY lamp section
is has been past through the hole in the illumination guide
section on the top of the case assembly. (Fig. 7)
P T
T
L O W
L A M
P
The packing TX/BUSY lamp section is has
been past through the hole in the illumination
guide section on the top of the case assembly.
Fig. 7
(2)Align the speaker lead as show n fig.8. Do not place the
leads over the key top section, LCD section or SP/M IC/DC
IN cap section.
Fig. 8
7. Cautions for installing the key top on the case assembly
(1)Install the key top keypad section and the pow er sw itch
section on the rib of the case assembly.
(2)Do not fix the part betw een the key top keypad section and
the pow er sw itch section to the rib of the case assembly,
but install it as show n in Fig. 8.
Do not fix this part of the
key top to the rib of the
case assembly.
5