ECS NFORCE4M-A Manual page 43

Primary/Secondary Master/Slave UltraDMA (Auto)
Each IDE channel supports a master device and a slave device. This motherboard supports
UltraDMA technology, which provides faster access to IDE devices.
If you install a device that supports UltraDMA, change the appropriate item on this list to
Auto. You may have to install the UltraDMA driver supplied with this motherboard in order
to use an UltraDMA device.
IDE DMA transfer access (Enabled)
This item allows you to enable the transfer access of the IDE DMA then burst onto the PCI
bus and nonburstable transactions do not.
Serial-ATA Controller (All Enabled)
This item allows you to enable or disable the onboard SATA controller.
IDE Prefetch Mode (Enabled)
The onboard IDE drive interface supports IDE prefetching, for faster drive access. If you
install a primary and secondary add-in IDE interface, set this field to Disabled if the
interface does not support prefetching.
Press <Esc> to return to the Integrated Peripherals page.
RAID Config (Press Enter)
Scroll to this item and press <Enter> to view the following screen:
Phoenix-Award WorkstationBIOS CMOS Setup Utility
RAID Enable
x
SATA 1 Primary RAID
x
SATA 1 Secondary RAID
x
SATA 2 Primary RAID
x
SATA 2 Secondary RAID
: Move Enter: Select +/-/PU/PD:Value F10:Save ESC:Exit F1: General Help
F5:Previous Values
RAID Enable (Disabled)
This item allows you to enable or disable the onboard RAID function of RAID function of
RAID supporting devices.
•
SATA 1/2 Primary/Secondary RAID (Disabled): These four items enable
or disable the SATA 1/2 Primary/Secondary RAID.
Press <Esc> to return to the Integrated Peripherals page.
RAID Config
[Disabled]
Menu Level
Disabled
Disabled
Disabled
Disabled
F6:Fail-Safe Defaults F7:Optimized Defaults
Using BIOS
Item Help
37