Benchmark And Info Menu - Worcester Greenstar 4000 Installation And Maintenance Instructions Manual

7.2.2

Benchmark and Info menu

Menu item
Flow temp.
Table 22 Benchmark menu
Menu item
Current status
Current fault
Fault history
Boiler
Max. heat output
Actual temp.
Set flow temp.
HEx temperature
Act. burner mod.
Burner output
Ionisation current
Pump mod.
Outside temp.
Burner starts
Hours run
System pressure
Hot water
Max. output
1)
DHW act. temp.
1)
S Act.temp. cyl.
1)
DHW set temp.
System
Contr.device ver.
Progr. unit ver.
SW sub-ver.
Code plug no.
Code plug ver.
2)
Key
3)
Solar
Collector temp.
Cyl.temp.bottom
Collector pump
Solar fault
1) Menu item only visible if integral diverter kit is fitted.
2) Only available with installed Key Timer (accessory)
3) Menu items only visible if Solar connected
Table 23 Info menu
Greenstar 4000 – 6 720 891 162 (2020/09)
Remark/restriction
Flow temperature in °C
Remark/restriction
 10.1.2 "Operating/Fault code table", page 71 for operating codes.
 10.1.2 "Operating/Fault code table", page 71 for fault codes.
Last 10 faults in chronological order
Maximum heating output in kW
Current flow temperature in °C
Target flow temperature in °C
Primary heat exchanger temperature
Current burner modulation %
Current burner output in kW
Current ionisation current in μA
Current pump modulation %
Current outside temperature in °C
Number of burner starts since commissioning
Run time of the system since commissioning
Current operating pressure in bar
Maximum domestic hot water output in kW
Current domestic hot water temperature in °C
Current domestic hot water temperature in °C
DHW temperature setting value
Software version of the control device
Software version of the control unit
Software sub-version
Code plug number
Code plug version
Type of control Key installed e.g. "Comfort+RF Key
Collector temperature in °C
Cylinder temperature, bottom sensor in °C
Collector pump
Current faults
Settings in the service menu
53