Standard Equipment; Telescope Assembly; Set-Up Tripod; Attach Telescope And Finderscope - Bushnell Voyager 78-9440 User Manual

STANDARD EQUIPMENT

Refractor Telescope Assembly
Exclusive Metal Easy Track® Mount
Variable Height-Aluminum Tripod
Exclusive Penta Mirror Assembly
8mm, and 12.5mm focal length - Eyepieces.
Red Dot Finderscope
Accessory Tray
1.5x Erecting Lens
2.5x Barlow
Hardware Packet—(3) Tripod Bolts with Wing Nuts, (3) Short
Accessory Tray Bolts with Wing Nuts, (3) Tripod Leg Lock
Screws

TELESCOPE ASSEMBLY

1.
Remove all components from the carton and identify all components. It is a good idea to lay
all the parts out in front of you before assembly. READ THROUGH ASSEMBLY INSTRUCTION
BEFORE YOU ASSEMBLE YOUR TELESCOPE. The only tool required in setting up your
telescope is a slotted or Phillips blade screwdriver.
optical system the parts require careful handling--particularly the telescope, eyepieces, and
various accessory lenses.

2. Set-Up Tripod

Select one tripod leg. Loosen
For a moment, do not extend the leg fully...a shorter leg is less awkward to work with during set-up.
Tighten the
Tripod Leg lock Screw
remaining two legs.
3.

Attach Telescope and Finderscope

Note: Before assembling tripod legs to Easy Track® Mount,
make sure the Accessory Tray Braces (7) face inward.
Loosen long bolts at the top of
mount over the
Easy Track® Mount
remaining two
to the mount, securely tighten all wing nuts in
Tripod Legs
place
.
Locate the pre-assembled
Remove
Main Tube Locking Nuts (3)
extending from bottom of
extended screws into holes in cradle of
Mounting System.
Remove plastic insert on bottom side of finderscope to
allow battery to make connection with battery contact for
power. Turn power switch on. See finderscope page.
Look through main telescope tube at low power and establish a well-defined stationary target.
Looking through red dot finderscope, alternate tightening each adjustment wheel (at rear and left
side of finderscope) until the red dot of finderscope is precisely aligned and centered on the same
object being viewed in main telescope tube. See finderscope page.
Tripod Leg Lock Screw (9)
so that the
Tripod Leg (5).
as shown
Tripod Leg
to
Tripod Leg
. Once you have attached all
Tripod Legs
Telescope Main Tube (2)
Telescope Main Tube (2).
Re-fasten
Main Tube Locking Nuts (3).
Since your telescope is a precision
and extend the
Middle Section
Position the
and secure
(fig. 2).
. Repeat on the
.
from screws
Insert
Easy Track®
Fig. 1
Tripod Leg Middle Section (6).
is securely in place. Repeat for the
Fig. 2