Standard Equipment; Telescope Assembly - Bushnell Deep Space 78-9518 User Manual

STANDARD EQUIPMENT

Reflector Telescope Assembly
Equatorial Mount
Variable Height-Hardwood Tripod
4mm, 12mm, 20mm focal length - Eyepieces.
5 x 24 mm Finderscope w/ focus adjustment
Accessory Tray
3x Barlow
Accessory tray: 3-_" bolts, 6-_" washers, 3-wingnuts

TELESCOPE ASSEMBLY

1. Remove all components from the carton and identify all components. READ THROUGH ASSEMBLY
INSTRUCTION BEFORE YOU ASSEMBLE YOUR TELESCOPE.
2. Set-Up Tripod
Select one tripod leg. Loosen
Tighten the
Tripod Leg lock Screw
remaining two legs.
3. Attach Telescope and Finderscope
Locate the pre-assembled
Equatorial Mount (20). Note: Before assembling tripod legs to
Equatorial Mount, make sure the Accessory Tray Braces (9) face
Loosen long bolts at the top of
inward.
Carefully remove
Position the mount over the
secure
Equatorial Mount
remaining two
Tripod Legs
to the mount, securely tighten all wing nuts and place
Legs
Telescope Main Tube
Locate the
Finderscope (1)
Remove the two nuts located near the front of the
(2).
telescope (closet to the eyepiece) and place the
and
Finderscope Mount
Finderscope Focus Adjustment (16)
Primary Mirror (14).
the
Finderscope
1. Attach Accessory Tray
Locate the
Accessory Tray (10).
Accessory Tray
Wingnuts should be positioned beneath the accessory tray. Do not tighten wingnuts until all
Accessory Tray Braces
2. Attach Control Cables, Counterweight and Eyepieces
Locate the
Fine Adjustment Cables (5).
Adjustment Cables
. The first post is located just above the
Mount
below the
Right Ascension Scale (24).
Tripod Leg Lock Screw (11)
so that the
Telescope Main Tube (15)
Telescope Main Tube
Tripod Leg
to
Tripod Leg
. Once you have attached all
back into .
Cradles
with pre-assembled
over the exposed screws. The
should point towards the
Replace the nuts, and securely tighten
and
Finderscope Mount
Using the accessory tray bolts, wingnuts and washers connect the
to the
Accessory Tray Braces (9)
are attached as some adjustments may be required.
and attach the
Fine Adjustment Cables
and extend the
Middle Section
and
Tripod Leg (12).
from
Cradles (25).
as shown and
(fig. 2).
. Repeat on the
Tripod
Finderscope Mount
Finderscope
in place.
. Start with one tripod leg and attach wingnuts.
Loosen the silver screws located at the end of the
to the two silver posts found on the
Declination Lock Knob (18)
18
19
20
21
fig. 1
Tripod Leg Middle Section (8).
is securely in place. Repeat for the
fig. 2
, the second post is located
25
24
23
22
Fine
Equatorial