Bushnell Voyager 78-9565 User Manual
  1. Manuals
  2. Brands
  3. Bushnell Manuals
  4. Telescope
  5. Voyager 78-9565
  6. User manual

Bushnell Voyager 78-9565 User Manual

565 x 60 refractor telescope
Hide thumbs
Table of Contents

Advertisement

Quick Links

565 x 60 Refractor Telescope
Model 78-9565

Advertisement

Table of Contents
loading

Related Manuals for Bushnell Voyager 78-9565

Summary of Contents for Bushnell Voyager 78-9565

  • Page 1 565 x 60 Refractor Telescope Model 78-9565...

  • Page 2: Telescope Assembly

    READ THROUGH ASSEMBLY INSTRUCTION BEFORE YOU ASSEMBLE YOUR TELESCOPE. The only tool required in setting up your telescope is a slotted or Phillips blade screwdriver. Since your telescope is a precision optical system the parts require careful handling--particularly the telescope, eyepieces, and various accessory lenses.
  • Page 3 Insert into focusing tube to begin viewing. Eyepiece (17) Your Bushnell Voyager Telescope is now ready to be used. To obtain the fullest enjoyment from your telescope, please refer to the additional information below. HOW TO USE YOUR NEW TELESCOPE Astronomical telescopes are designed in such a way that the image you will see UPSIDE DOWN and REVERSED, this is acceptable for viewing celestial bodies.
  • Page 4 Remove plastic insert on bottom side of finderscope to allow battery to make connection with battery contact for power. Turn power switch on. Look through main telescope tube at low power and establish a well-defined stationary target. Looking through red dot finderscope, alternate tightening each adjustment wheel (at rear and left side of finderscope) until the red dot of finderscope is precisely aligned and centered on the same object being viewed in main telescope tube.
  • Page 5 750 mm 2. Included with this telescope is a Barlow lens. Barlow lenses are used to double or triple the power of your telescope. Place your Barlow between the focusing tube and the Penta Mirror. Note: The Penta Mirror...
  • Page 6 Venus are good second steps to take. 2. The first thing you need to do after assembling the telescope as planned is center the desired object in the finderscope's cross hairs. Provided you did a reasonable job aligning the finderscope, a quick look through the main telescope tube at low power should reveal the same image.
  • Page 7 Where do I start? Your Bushnell telescope can bring the wonders of the universe to your eye. While this manual is intended to assist you in the set-up and basic use of this instrument, it does not cover everything you might like to know about astronomy.
  • Page 8 The telescope focal length is the same focal length as the objective focal length. For this telescope it is 750mm. Telescope focal lengths range from 600mm to 900mm on Bushnell Telescopes. Telescopes with power ranging from 25X to 50X can be used to view Star Clusters and Nebulae.
  • Page 9 TROUBLESHOOTING GUIDE If after you have set-up your new telescope you are unable to see any objects, use this Quick Reference guide to help you to understand the cause of the problem and quickly determine a remedy 1. I’ve completed the set-up yet I cannot see anything Check to see if objective lens cover has been removed.
  • Page 10 Bushnell * 8500 Marshall Drive * Lenexa, Kansas 66214 IN CANADA Send To: Bushnell * 25A East Pearce Street, Unit 1 * Richmond Hill, Ontario L4B 2M9 For products purchased outside the United States and Canada please contact your local dealer for applicable warranty information.

Table of Contents