Control Center; Operation - York MILLENNIUM YK Operating & Maintenance

CONTROL CENTER

CHARACTERISTIC DISPLAY –
STATUS
DISPLAY –
ENTRY –
PROGRAM
SETPOINTS –
DISPLAYING SYSTEM PARAMETERS
Display
Display
8
CONTROL CENTER
Setpoint
PROGRAM
Entry

OPERATION

Display
Display
Display
DISPLAY HOLD
SERVICE –
ACCESS CODE –
PROGRAM –
MODE –
SERVICE
Service –
Local –
COMPRESSOR
Program –
Remote –
COMPRESSOR-START,
SWITCH –
REMOTE
DISPLAY HOLD
NOTE: If the display actually displays X’s, then the
monitored parameter is out of normal operat-
ing range (refer to Fig. 4). If the “English/Met-
ric” jumper is installed on the Micro Board, all
temperatures are displayed in degrees Fahr-
enheit (°F) and all pressures are displayed in
pounds per sq. inch gauge (PSIG) except oil
pressure which is displayed in pounds per sq.
inch differential (PSID). If the “English/Metric”
jumper is not installed, all temperatures are
displayed in degrees Centigrade (°C) and all
pressures are displayed in Kilo-Pascals (kPa).
LOCAL, REMOTE
RUN, STOP/RESET