Chapter 2
GPIB Software Installation
AT-GPIB/TNT (PnP) for Windows NT
Figure 2-1. NI-488.2M Software for Windows NT Installation Screen
The setup program takes you through the necessary steps to install
the NI-488.2M software. For help during the installation, click on the
Help button. To exit the setup program at any time, click on the Exit
button.
When the setup program has finished copying the software to your
computer, it attempts to start the NI-488.2M driver. If the setup
program cannot start the driver, it instructs you to restart
Windows NT, which forces the driver to load.
Next, you need to enable support for ISA Plug and Play hardware in your
system. Proceed to Chapter 3, Plug and Play Software Installation.
2-2
© National Instruments Corporation