Chapter 3
Software Installation and Configuration
This chapter contains instructions to help you install and configure your NI-488.2M
software.
Before you install the software, consider the following:
•
You must have super-user privilege.
•
The NI-488.2M distribution disk is in tar format.
•
If you have the default module of the National Instruments ESP-488 for LynxOS
device driver (esp488.o) installed on your system, you must remove the ESP-488
driver before installing the NI-488.2M driver. Other ESP-488 driver modules (for
example, esp488_2.o) can safely coexist with the NI-488.2M driver as long as the
drivers are not configured to control the same GPIB board(s).
NI-488.2M Software Components
The NI-488.2M distribution disk contains the following files:
•
cib.c is the C language interface library.
•
cib.h is the private include file for cib.c .
•
ib.cfg is the LynxOS configuration file for the NI-488.2M driver.
•
ib_lynxos.o is the NI-488.2M driver for the GPIB board.
•
ibconf is the software configuration utility.
•
ibic is the interface bus interactive control utility.
•
ibinfo.c is the GPIB board configuration file for manual software installation.
•
ibinfo.h is the private include file for ibinfo.c.
•
ibtsta is the software installation test, part A.
•
ibtstb is the software installation test, part B.
•
instgpib is the automatic install script for the driver.
•
ugpib.h is the include file for user programs.
© National Instruments Corp.
3-1
AT-GPIB/TNT for LynxOS