Brother HL-3400CN Series User Manual page 146

4. Press the Set button to make the displayed selection effective.
The printer is reset according to the selected reset mode.
Selected Mode
RESET PRINTER
RESET SETTING 1-2
FACTORY SETTINGS
1* - # indicates the selected number of saved settings
The printer automatically exits from the reset mode to the on-
line state.
5. When you enter the RESET PARTS LIFE mode:
LCD Message
FC ROLLER
OPC BELT
FUSER UNIT
240K KIT
The reset item is selected according to the Maintenance message that
shows the currently recommended part to replace. Press Set to reset
the parts life. See
List of Factory Settings
The following table shows the factory settings made before shipment.
Notes
The settings are subject to the emulation mode. Effective modes are
indicated in parentheses in the following table.
The following settings cannot be restored to the factory settings with
the Reset button in the "FACTORY SETTINGS" mode:
INTERFACE MODE, HRC SETTING, PAGE PROTECTION,
SCALABLE FONT, LOCK PANEL, PAGE COUNTER and local
LANGUAGE for display messages.
The COPY setting is always restored to the factory setting when the
printer is turned off and on again.
The user settings are overwritten after resetting to User Settings 1 or
2.
LCD message
08 RESET TO
08 RESET TO
09 RESET TO
SETTINGS
Parts replaced
Fuser Cleaner
(OPC) Belt Cartridge
Fixing Unit
Drum Cleaner, Paper Discharge,
Transfer Roller
Chapter 5 for more detailed information.
CHAPTER 4 CONTROL PANEL
USER SETTINGS
SETTING # 1*
FACTORY
4–75