Brother HL-2700CN series User Manual page 120

5
Put the new fusing unit into the printer. Be sure to insert the fusing unit completely into the printer.
6
Secure the fusing unit with the two lock levers that are on both sides of the fusing unit.
7
Move the fusing unit pressure release levers to the Set position.
8
Close the back cover.
9
Turn the printer power switch back on.
10
Menu
Press any of the
11
Press + or – until RESET MENU appears.
12
Set
Press to proceed to the next menu level, and then press
13
Set
Press , and then press
14
Set
Press . The printer is now in the READY state.
Please be careful when replacing the fusing unit. Do not put pressure on the fusing unit; it should
go in easily. If it does not, make sure the fusing unit connector is free to move.
Do not apply force! It could damage both the fusing unit and the printer.
Figure 5-17
Figure 5-18
Figure 5-19
+ – Set Back
buttons ( , , or
+
until FUSER UNIT appears.
) to take the printer off line.
+ –
or until PARTS LIFE appears.
ROUTINE MAINTENANCE 5 - 15