Scan to Image
When you choose Scan to Image, your document will be scanned and sent directly to the Macintosh
designated on your network. ControlCenter2 will activate the default graphics application on the designated
®
Macintosh
. You can change the Scan configuration. (See Image (example: Apple PreView) on page 136.)
a
Put the document face up in the ADF, or face down on the scanner glass.
b
Press
(Scan).
c
Press a or b to choose Scan to Image.
Press OK.
If your machine is a MFC-8460N or DCP-8060, go to Step e.
If your machine is a MFC-8860DN, go to Step d.
d
Press a or b to choose 2sided (L)edge, 2sided (S)edge or 1sided.
Press OK.
Note
If you want to scan a document using the duplex scanning feature, you need to put the document in the
ADF and then choose 2sided (L) edge or 2sided (S) edge depending on your document layout.
e
Press a or b to choose the destination Macintosh
Press OK.
If the LCD prompts you to enter a Pin number, enter the 4-digit Pin number for the destination
®
Macintosh
on the control panel.
Press OK.
The machine will start the scanning process.
®
you want to send to.
10.
10
®
you
155