3. Push the release buttons on the battery and pull the
battery out.
To adjust the handle
The rear handle of the hedge trimmer can be adjusted in
five positions.
Introduction
WARNING: Read and understand the safety
chapter before you do maintenance work on
the product.
WARNING: Remove the battery before you
do maintenance on the product.
Maintenance
Clean the external parts of the product.
Examine that the start and stop switch works correctly and is not damaged.
Make sure that the power trigger and the power trigger lockout function correctly
from a safety point of view.
Make sure that all controls work and are not damaged.
989 - 001 - 21.01.2019
1. Stop the product.
2. Make sure that the cutting equipment stops.
3. Release the power trigger.
4. Pull the lock for the handle and turn the handle.
5. Make sure the control panel on the handle faces up
no matter the angle of the cutter blade.
To cut the hedge
•
Move the product from the bottom up when you cut
the sides.
•
Point the motor away from the hedge.
•
Hold the product as near to your body as possible for
the correct balance.
•
Make sure that the point of the cutter blade does not
touch the ground.
•
Do not cut too quickly. Cut slowly and continuously
until you get a good quality cut.
Maintenance
Maintenance schedule
The following is a list of the maintenance steps that you
must do on the product.
WARNING: Remove the battery before you
do maintenance.
Before
Weekly
use
X
X
X
X
Monthly
11