Table of Contents
Advertisement
RUGGEDCOM WIN5123
Installation Guide
5.
Tighten the screws connecting the clamping bracket to the mounting bracket. Make sure the screws are
torqued to 14 N·m (10 lbf-ft).
Section 2.1.2
Mounting the Device to a Wall or Tower
Attach the device to any wall capable of carrying the device's weight. An outer wall on a roof or other high
location to avoid interference from other buildings or trees is preferred.
3
9
Figure 6: Mounting the Device to a Wall or Tower
1. CPE
2. Mounting Kit
Flat Washer
9. Screw for Chipboard
To mount the device to a wall, do the following:
1.
Select a mounting location on the wall.
2.
Place the mounting bracket on the wall and mark 4 mounting holes.
3.
Drill 4 holes and insert a wall plug into each hole.
4.
Secure the mounting bracket to the wall with 4 type NS 1/4" × 1/2" HEX screws, 4 spring washers, and 4 flat
washers.
5.
Connect the arm bracket to the mounting bracket using a screw, spring washer and washer. Make sure the
screw is hand tightened.
6.
Connect the device to the arm bracket using a screw, spring washer and washer. Make sure the screw is
hand tightened.
7.
Adjust the position of the device. For more information about how to align the CPE Antenna, refer to
Section 2.2, "Installing the
Mounting the Device to a Wall or Tower
2
8
10
4
5
6
3. Wall Holder/Pole Mount
10. Wall Plug (Plastic Anchor)
Antenna".
4. M8-25 Hex Screw
5. M8 Flat Washer
Installing the Device
5
7
6
6. Spring Washer
Chapter 2
1
2
7. M8 Nut
8. M5
11
Advertisement
Table of Contents
