Sony MVS-8000 User Manual page 76

When the independent key transition control block (simple type) is
installed in the main base
Select the keys to be assigned from the following.
• Key1,2 (keys 1 and 2)
• Key3,4 (keys 3 and 4)
• DSK1,2 (downstream keys 1 and 2)
• DSK3,4 (downstream keys 3 and 4)
• N/A (no assignment)
In this case, "Key1,2" and "Key3,4" are the keys of the switcher bank (M/E-1,
M/E-2, M/E-3, PGM/PST) in which the independent key transition control
block is installed and whose assignment is determined by the M/E Assign
menu.
When the independent key transition control block (simple type) is
installed in the extension section
Select the keys to be assigned from the following.
• M/E-1 Key1,2
• M/E-1 Key3,4
• M/E-2 Key1,2
• M/E-2 Key3,4
• M/E-3 Key1,2
• M/E-3 Key3,4
• DSK1,2
• DSK3,4
1)
• Key1,2
1)
• Key3,4
1) In this case, depending on the switcher extension interface port, operations always apply to
the following.
Ext Port 1: M/E-1
Ext Port 2: M/E-2
Ext Port 3: M/E-3
• N/A (no assignment)
To assign a key to the independent key transition control block (simple type),
use the following procedure. Here the example shown is the case in which keys
3 and 4 ("Key3,4") are assigned to the second row switcher bank of the main
base.
1
In the Panel >Config menu, press [Compact Key Module Assign].
The Compact Key Module Assign menu appears.
The left side of the status area shows data for the main base (physical
layout and switcher bank names and key assignment). The right side shows
the data for the extension section (physical ports and key assignment).
2
Press directly on the display on the left, to select the control block for the
assignment.
Overall Control Panel Settings (Config Menu)
75