Sony MVS-8000 User Manual page 268

Icon Title Message
Extraction Still frame on FM 2nd board (–
51).
Clip frame number can't be
ODD in 720P format (–9).
File Auto Can't convert file. It is not
Convert supported version.
File Frame Some requests are skipped.
Memory Following operation is not
permitted.
— Loading that will cause
duplicate register name.
File Open ERROR (01)
Status
ERROR (02)
ERROR (FF): No target device
has been assigned
Format Success!!
Description
2542:Frame Memory >File >Auto Extraction
In the above menu, when [Extraction Start] is
pressed, this message appears if a still image
was extracted from an external clip.
2542:Frame Memory >File >Auto Extraction
In the above menu, when [Extraction Start] is
pressed, this message appears if an odd
number of clips are extracted (720P format
only).
7316.8: Engineering Setup >System >Install/
Unit Config >Unit Config
This appears when in the above menu, even
though the automatic data conversion function
is enabled, an attempt was made to read the
data of which version is not supported by the
conversion engine, and the data read therefore
failed.
7151: File >Frame Memory
7162: File >All, External File >Import/Export
In the above menu, an attempt was made to
load a file of a name already existing in the
register.
533X: Device >DDR/VTR
When an error is returned from the DDR/VTR,
one of these messages appears, depending on
the error number.
Use Menu 7355: Engineering Setup >DCU
>Serial Port Assign or Menu 7325.4:
Engineering Setup >Panel >Device Interface
>Serial Port Assign to check the device
settings.
2561: Frame Memory >External HDD >Format
In the above menu, formatting the external hard
disk completed successfully.
267
Error Messages