Original Vacusweep Inlet Valve Installation Instructions - NuTone VX1000C Installation Instructions Manual

ORIGINAL VACUSWEEP
INSTALLATION INSTRUCTIONS
CONNECTION FROM
BELOW
Refer to Figure 48.
1. Turn the power to the vacuum unit OFF.
Measure distance (X) between the kickplate
face and the inside edge of the cabinet. Then,
add 2 ¾" to the measured distance. See Figure
48-1. Measure out the new distance (X+2 ¾")
from the cabinet door to the reference mark.
2. Drill a small reference hole straight down
through to the basement. See Figure 48-2.
Locate the reference hole in the basement and
verify that there are no obstructions within 2" of
either side and 4" behind.
3. Cut a 2 ½" diameter hole from the basement up
into the base of the counter using the
reference hole as a center. See Figure 48-3.
4. Using the reference hole as a center, cut a
2 3/8" high x 6 5/8" wide rough opening in the
kickplace face. See Figure 48-4.
5. Glue the long socket of the tight elbow (part no.
CF382S) onto a section of 2" central vacuum
pipe. Make the terminal connections to the
VacuSweep ® Inlet Valve by sliding the low voltage
wire into wire clips. Turn the power to the vacuum
unit on to test the connection. After successful
completion of the test, turn power to the vacuum
unit OFF. Wrap a piece of wire/string around
the pipe. Using the wire/string to temporarily
hold the pipe and elbow in place, insert the
VacuSweep ® Inlet Valve into the cabinet base
and elbow. DO NOT glue this connection
(Designed for friction fit). See Figure 48-5.
6. Remove the wire/string. With the door in an
open position, secure the VacuSweep
Valve to the cabinet base using #6 screws. See
Figure 48-6. Ensure that the spring on the
electrical connector has 1/8" clearance to
rough opening. Continue with remainder of
central vacuum connections. When the vacuum
system is complete, turn the power to the vacuum
unit on.
INLET VALVE
® Inlet
FIGURE 48
23
®