Model 330 & Ci335 Wall Inlets - NuTone VX1000C Installation Instructions Manual

5. Attach the low voltage wires to terminal screws on back
of wall inlet (Figure 35). If using 361 Rough-in with CI370
Series Inlets, refer to instructions on page 7, step 3,
shown in Figure 10.
FIGURE 35
6. Insert wall inlet into bracket and secure with the two
screws provided (Figure 36).
FIGURE 36
MODEL 330 & CI335 SERIES
WALL INLET INSTALLATION
CF329 ROUGH-IN)
1. Make cutout according to dimensions in Figure 37.
2. Refer to Figure 38. Break off nail plate at scored line.
3. Refer to Figure 39. Glue elbow to mounting plate, place
assembly into cutout, and attach elbow to tubing inside
the wall.
4. Make sure mounting holes are exactly at top and bottom.
5. Connect 2-conductor low voltage wire to terminal screws
on back of wall inlet.
6. Refer to Figure 40. Align inlet mounting holes with
mounting plate holes, place inlet into mounting plate, and
secure with provided screws.
1
/ "
4
2 3 / "
4
3 / " DIA.
8
7
3 / "
8
3
/ " DIA.
8
3
1 / "
8
1
/ "
4
FIGURE 37
MOUNTING
PLATE
ELBOW
MOUNTING
HOLE (2)
FIGURE 39
NOTE: If CF382S shorter radius elbow is used, it may
be necessary to use the short mounting screw to avoid
interference with elbow.
19
FIGURE 38
INLET
MOUNTING
PLATE
FIGURE 40