Assembly Of Control Head To Transceiver; Dash Mount Models; Remote Mount Models; Figure 5-18. Cover Gasket Location - Motorola MCS 2000 Service Instructions Manual

Disassembly & Reassembly and Replacement Procedures: Transceiver Reassembly Low and Mid Power Models 5-
2. Place a new cover gasket around the chassis ensuring that it is placed under the locking tabs
and ledge at the front of the chassis
seated along the groove, twist the gasket between fingers down and toward the chassis on
both sides of the chassis.
3. Install the top cover by engaging the hooks on front of the chassis and rotating the cover
back.
On Mid Power Models: Ensure that the side snaps on the cover are engaged.
On Low Power Models: Ensure that the side snap in the back is engaged.
4. Install the front cover gasket over the front of the transceiver ensuring that the rectangular
hole in the transceiver aligns with the rectangular hole in the gasket. Press the gasket flush
against the transceiver to ensure proper sealing.
5. Install the accessory connector assembly through the bottom side of the radio. Be sure to
install the connector straight down into the unit because otherwise it will catch on the housing
and no connection will be made.

Assembly of Control Head to Transceiver

Refer to exploded views on pages 10-4 to 10-9 for parts referenced in this procedure.

Dash Mount Models

For Model I: Install dash mount configured control head onto the transceiver. Ensure that the side
snaps are engaged.
For Models II and III: Install the retention frame over the front of the transceiver. Install the dash
mount configured control head onto the transceiver. Slide the retention frame toward the control
head until both snaps engage.

Remote Mount Models

1. Install the 18 position connector into the female connector (mounted on the PC board)
through the hole in the front of the chassis.
2. Install the remote header retainer into the recess for the rectangular cutout in the remote front
housing.
3. Place white remote retainer (4205395X01) over 18 position connector.
4. Install the remote front housing over the 18 position connector onto the front of the trans-
ceiver ensuring that both snaps are engaged.
5. Connect the remote mount cable to the transceiver and to the remote mount configured con-
trol head.
68P81083C20-D
Twistouring
Cover gasket

Figure 5-18. Cover Gasket Location

(See Figure 5-18.). To ensure that the gasket remains
December 6, 2004