Table of Contents
Advertisement
•
When removing the safety equipment the fixation means should be stored for later use. Removed
safety equipment must be reinstalled prior to starting up.
•
Notices attached to the gear unit, such as rating plate, direction arrows, must always be observed. They
must be kept free from dirt and paint at all times. Missing plates must be replaced.
•
Screws which have been damaged during assembly or disassembly work must be replaced with new
ones of the same strength class and type.
•
Spare parts should always be obtained from Siemens (see also section 11).
3.2
Environmental protection
•
Compliance with local environmental protection requirements during operation and in particular during
maintenance and repair work on the gear unit is the responsibility of the operator.
•
Dispose of any packaging material in accordance with regulations or separate it for recycling.
•
When changing oil, the used oil must be collected in suitable containers. Any pools of oil which may
have collected should be removed at once with an oilbinding agent.
•
Preservative agents should be stored separately from used oil.
•
Used oil, preservative agents, oilbinding agents and oilsoaked cloths must be disposed of in
accordance with environmental legislation.
•
Disposal of the gear unit after its useful life:
─ Drain all the operating oil, preservative agent and/or cooling agent from the gear unit and dispose
of in accordance with regulations.
─ Depending on national regulations, gearunit components and/or addon parts may have to be
disposed of or sent for recycling separately.
3.3
Special dangers and personal protective equipment
•
Depending on operating conditions, the surface of the gear unit may heat up or cool down to extreme
temperatures.
In the case of hot surfaces (> 55 °C) there is a risk of burns!
In the case of cold surfaces (< 0 °C) there is a risk of frost injury (pain, numbness,
frostbite)!
During oil changes there is a risk of scalding from escaping oil!
Small foreign matter such as sand, dust, etc., may often easily find their way past the
guards of the rotating parts and be thrown around by them.
Risk of eye injury!
In addition to any generally prescribed personal safety equipment (such as safety shoes,
safety clothing, helmet) handling the gear unit requires wearing suitable safety gloves and
suitable safety glasses!
The gear unit does not comply with the requirements in Directive 94/9/EC and must
therefore, in the area of applicability of this directive, not be used in potentially
explosive areas.
Caution, serious danger!
Should the gear unit be used outside the area of applicability of Directive 94/9/EC
within potentially explosive areas, the nationally applying protective prescriptions
with regard to explosion protection must always be observed.
BA 5200 EN 08/2010
15 / 65
Advertisement
Table of Contents
