Remote Commands - Brother FAX 2750 Owner's Manual

Remote Commands

Follow the commands below to access features remotely. When you call the
fax machine and enter your Remote Access Code (1 5 9 ), the system will
signal you with two short beeps to enter a remote control command.
Remote Control Commands
95 Changing Fax Forwarding
/Paging setting
1 OFF
2 Fax Forwarding
3 Paging
4 FAX FWD No.
6 Fax Storage ON
7 Fax Storage OFF
96 Retrieve FAX
1 Memory Status List
2 Retrieve all faxes
3 Erase fax from the
memory
97 Check the receiving status
1 FAX
98 Change Answer Mode
1 TAD
2 FAX/TEL
3 FAX
90 Exit
R E M O T E F A X O P T I O N S
Operation Details
If you hear one long beep, the change is accepted. If
you hear three short beeps, you cannot change it
because the conditions have not been met (Example:
registering paging number). You can register your fax
forwarding number by using 4. FAX FWD NO (see
page 71). Once you have registered the number, the
fax machine will change automatically to
FAXFWD:ON mode. Then retrieve a Memory Status
List by entering 961 (see page 76) to make sure that
the Fax Forwarding number you registered is correct
in the List.
You can set FAX STORAGE ON or OFF.
Enter the number of a remote fax machine to receive
the Memory Status List or stored fax message(s). (See
page 76.)
If you hear one long beep, you can erase fax
message(s) from the memory.
You can check whether your fax machine has received
any fax message(s). If yes, you will hear one long
beep. If no, you will hear three short beeps.
If you hear one long beep, you can change the Answer
Mode. If you hear three short beeps, you cannot
change it.
After a long beep, you can exit remote control.
75