Connections; Recording Outgoing Message On External Tad - Brother FAX 2750 Owner's Manual

18
C H A P T E R T W O

Connections

The external TAD must be plugged into the left side of the fax machine, into
the jack labeled EXT. Your fax machine cannot work properly if you plug
the TAD into a wall jack.
1
Plug the telephone line cord from the wall jack into the left side of the
fax machine, in the jack labeled LINE.
2
Plug the telephone line cord from your TAD into the left side of the
fax machine, in the jack labeled EXT. (Make sure this cord is connected to
the TAD at the TAD's telephone line jack, and not its telephone set jack.)
3
Set your external TAD to four rings or less. (The fax machine's Ring Delay
setting does not apply).
4
Record the outgoing message (see below).
5
Set the TAD to answer calls.
6
Set the Answer mode to TAD. (Press
TEL lights are on.)

Recording Outgoing Message on External TAD

Timing is important in recording this message. The message sets up the
ways to handle both manual and automatic fax reception.
1
Record 5 seconds of silence at the beginning of your message. (This
allows your fax machine time to listen for the fax CNG tones of
automatic transmissions before they stop.)
2
Limit your speaking to 20 seconds.
3
End your 20-second message by giving your Fax Receive Code for
people sending manual faxes. For example:
"After the beep, leave a message or send a fax by pressing
Start."
TAD
YES !
Mode
NO !
until both FAX and FAX/
5 1 and
TAD