Complete The Installation; Care And Cleaning - Kohler K-11344 Installation And Care Manual

9. Complete the Installation

Complete the Drain Installation
Secure the drain tailpiece to the P-trap.
Insert the plug into the drain outlet. Adjust the height of the plug, if needed.
NOTE: To ensure the setscrew does not inadvertently fall down the drain outlet, push down on the plug
to close the drain hole.
Secure the handle to the overflow outlet with the setscrew.
Turn the handle counterclockwise and clockwise to ensure proper operation of the plug.
Test Run the Bath
Fill the bath to a level at least 4" (102 mm) above the top of the highest airjet.
Operate the bath for 5 minutes and check all bath piping connections for leaks. Check for leakage
along the front, sides, and back of the bath.
Finish the Installation
Install the faucet trim.
Clean-up After Installation
When cleaning up after installation, do not use abrasive cleansers, as they may scratch and dull the
bath surface. Use warm water and a liquid detergent to clean the surface of the bath.

Care and Cleaning

For best results, keep the following in mind when caring for your KOHLER bath with airjets:
• Always test your cleaning solution on an inconspicuous area before applying to the entire surface.
• Wipe surfaces clean and rinse completely with water immediately after applying cleaner. Rinse and
dry any overspray that lands on nearby surfaces.
• Do not allow cleaners to soak on surfaces.
• Use a soft, dampened sponge or cloth. Never use an abrasive material such as a brush or scouring
pad to clean surfaces.
• The ideal cleaning technique is to rinse thoroughly and blot dry any water from the surface after
each use.
• Use a soft nylon brush on slip-resistant surfaces. Be sure to use a water-soluble cleaner (dissolves
100% in water).
• Do not use powdered cleaners unless the cleaner is fully dissolved in water. Solid substances can
block the airjets.
Kohler Co.
Overflow Outlet
Handle
Setscrew
Plug
Drain
Outlet
13 1220597-2-A