Roland CAMM-1 GR2-640 Setup Manual page 30

1. Assembly
Use the hexagonal wrench (large) to rotate the damper screw three times in the
2
direction of the arrow.
Insert the damper-equipped roll holder into the front notches on the roll holder
3
supports (up to the third set of notches can be used) with the damper on the left
side as seen from behind the machine.
Position the protrusion on the damper above the screw, and then insert the screw and pro-
trusion into the notch on the roll holder support. Firmly press the protrusion into the notch
on the roll holder support. The roll holder cannot be installed correctly if the protrusion and
screw positions are reversed.
ME MO
You can select the insertion position of the damper-equipped roll holder to match the roll material
to use.
Use the hexagonal wrench (large) to tighten the damper screw in the direction of
4
the arrow.
Tighten the screw until it is firmly secured on the roll holder support.
28
2.Installation