How To Remove The Cover - Chicco Easy Relax Instructions For Use Manual

the child sitting in the bouncing chair, although it can
be more difficult. Always hold the backrest with one
hand while adjusting its position.
HOW TO ADJUST THE FOOTREST
The footrest can be adjusted to two positions.
9. Low position: Press the buttons, located on the front
joints (E), and, at the same time, push the footrest in
a downward direction. A click is heard, signalling that
it is locked into position (diag.10).
10. High position: Press the buttons and push the foot-
rest in an upward direction. A click is heard, signal-
ling that it is locked into position (diag.11).
ROCKING POSITION
The baby chair can be used in the "rocking" position.
11. Turn the rear handle (B) following the direction of the
arrow (diag.12).
12. When you wish to use the bouncing chair as a baby
chair, turn the handle in the opposite direction to
prevent rocking (diag.13).

HOW TO REMOVE THE COVER

The cover of the baby-bouncing chair can be removed
and cleaned.
13. Remove the safety harness from the "D" rings; then
remove the cover starting from the front, first from
the footrest, unfastening the Velcro straps located
underneath, and then from the backrest (diag.14).
14. To replace the cover onto the bouncing chair, repeat
the above operations in the reverse order, sliding the
lower fabric strap through the adjusting joints of the
backrest (D), as shown in diagram 15.
WARNING: Fit the safety harness again, checking that
it has been fitted correctly through the holes of the "D"
rings and the crotch strap.
For further information or spare
parts requests, please contact
Chicco UK Ltd Customer Service:
Postal address: CHICCO UK LTD
PROSPECT CLOSE
KIRKBY IN ASHFIELD
NOTTINGHAMSHIRE - NG17 7LF
Telephone: 01623 750870
Website: www.chicco.co.uk
section "contact us"
13